Electrol DX 6 Channel x 2500 W Dimmer Pack (2) LSC Patch Output / Power Lock Input, D625dx-P19-PL

Electrol DX 6 Channel x 2500 W Dimmer Pack (2) LSC Patch Output / Power Lock Input, D625dx-P19-PL



A feature rich 19” rack mountable dimmer pack with six 2500W dimmers (versions with 1500W or 6000W dimmers are available). Two LSC 19-pin connectors are provided for the outputs.

***Twelve dimmer version shown in large photo***

Markets Served

Theatical, Motion Picture, Live Event

Features & Benefits

• Twelve 1500w dimmers
• Powerlock patch panel
• Two LSC 19-pin output connectors
• Easy to operate LED user interface for addressing and setup
• Controlled with DMX512, 0-10VDC analog, or on-board controller
• DMX start address or dimmer soft patching
• 100 internal presets
• Built in chase functions
• Programmable non-dim
• Lamp pre-heat feature
• Selectable output voltage top limit for low voltage fixtures
• Circuit breaker protected (no fuses)
• Neutral and ground miswiring protection
• Broadcast quality filtering
• Integrated DMX termination switch
• Suitable for resistive or inductive loads

Specifications

Power Capability: Six dimmers, 2500 watts each

Control: Industry standard DMX512 control or analog 0-10VDC. Levels may also be selected from the front panel without need for external control.

Control Input: Optically isolated DMX input. Gold plated 5 pin XLR DMX in and thru connectors. Analog connector is 15-pin D-sub. A DMX termination switch is provided.

Front Panel Display: Display provides clear indication of power, DMX data, DMX start address and soft-patching DMX assignments, pre-set levels and non-dim assignments.

Output Regulation: ± 2%.

Output Limit: Output voltage may be limited on a dimmer-by-dimmer basis to accommodate low-voltage loads.

Loads: Resistive or inductive

DMX Channel Assignment: Start address or soft patch mode (any or all dimmer channels may be assigned to any DMX control channel).

Lamp Pre-Heat: A minimum output level may be programmed into each dimmer.

Neutral Error: Innovative voltage sensing circuitry shuts down the dimmer when neutral or ground conductors rise to a potentially dangerous level.

Non-Dim: The unit may be configured to operate as a solid-state relay.

Filtering: Broadcast quality chokes. Dimmer’s rise time shall not exceed 450µs at full load.

Voltage Monitor: Input power connections may be verified by phase LEDs on the front panel display.

Input Power: One, two or three phase 120VAC

Overcurrent Protection: Magnetic circuit breakers

Output Connection: Two LSC 19-pin output connectors

Cooling: Thermostatically controlled fan

Construction: Steel chassis with black baked epoxy finish.

Rack Space Required: Two RU per pack

Approvals: UL and cUL